How to make glue for mice? - briefly
Mix equal parts of wheat flour and water, heat until a smooth, thick paste forms, then stir in a small amount of sugar to increase tackiness; allow the mixture to cool before use. Apply a thin, even coating to the trap surface with a brush, ensuring the adhesive remains moist for optimal effectiveness.
How to make glue for mice? - in detail
Creating an effective adhesive for rodent capture involves selecting safe, low‑toxicity components, measuring precisely, and following a controlled mixing process.
The basic formulation combines a water‑soluble polymer with a natural thickening agent. Common ingredients are:
- Polyvinyl alcohol (PVA) powder, 10 g
- Cornstarch, 5 g
- Warm distilled water, 100 ml
- A few drops of food‑grade glycerin (optional, for flexibility)
Begin by heating the water to approximately 80 °C. Dissolve the PVA powder gradually while stirring to avoid clumping. Once fully dissolved, introduce the cornstarch, maintaining continuous agitation to prevent lumps. Continue heating for 2–3 minutes until the mixture thickens to a syrup‑like consistency. If flexibility is desired, add glycerin at this stage and stir for an additional minute. Remove the solution from heat and allow it to cool to room temperature; the viscosity will increase as it cools.
For application, spread a thin layer of the adhesive on a non‑porous surface such as a glass plate or a plastic tray. Use a disposable brush or a spatula to achieve an even coating no thicker than 1 mm. Position the coated surface near known mouse pathways, ensuring it does not contact food sources or pets.
Storage guidelines:
- Transfer any unused adhesive into an airtight container.
- Keep the container in a cool, dark place.
- Use within 7 days; the mixture will solidify over time.
Safety considerations:
- Wear disposable gloves during preparation and application.
- Avoid inhaling dust from powdered ingredients.
- Dispose of used adhesive by sealing in a plastic bag and discarding with regular waste.
The described method yields a transparent, tacky substance that immobilizes rodents without exposing them to hazardous chemicals. Adjusting the polymer concentration can modify stickiness to suit different environments.