How should you correctly apply mouse glue? - briefly
Apply the adhesive to the mouse’s paws with a fine brush, spreading a thin, even layer while keeping it away from the eyes and mouth. Let the glue cure for the manufacturer‑specified duration before handling the animal.
How should you correctly apply mouse glue? - in detail
Applying mouse glue correctly requires preparation, precise placement, and safe handling. Begin by selecting a well‑ventilated area to minimize inhalation of fumes. Wear disposable gloves to protect skin and prevent contamination of the adhesive.
- Clean the target surface. Use isopropyl alcohol or a mild detergent to remove dust, oils, or residues. Allow the surface to dry completely before proceeding.
- Prepare the glue container. Shake gently to ensure uniform consistency, then open the lid or remove the seal according to the manufacturer’s instructions.
- Measure the required amount. Most applications need only a thin film; excess can cause spillage and attract unwanted debris. Use a calibrated pipette or a small spatula for accuracy.
- Apply the adhesive evenly. Hold the applicator at a 45‑degree angle and spread the glue in a continuous, thin layer across the intended area. Avoid pooling, which can impede the mouse’s movement.
- Position the mouse trap or bait. Place the device immediately after the glue has been laid, ensuring it contacts the adhesive without disturbing the film. Press gently to secure contact.
- Allow the glue to set. Follow the product’s curing time—typically 5–10 minutes—before exposing the setup to rodents. Do not disturb the trap during this period.
- Monitor and replace. Check the trap regularly; once the adhesive becomes saturated with dust or debris, discard it and repeat the process with fresh glue.
Safety considerations: keep the product out of reach of children and pets, store it in a sealed container away from heat sources, and dispose of used glue according to local hazardous‑waste regulations.