How do I use mouse glue? - briefly
Apply a thin layer of the adhesive to the trap surface, let it dry until tacky, then position the trap where rodents travel. Replace the glue when its stickiness fades.
How do I use mouse glue? - in detail
Mouse glue, also known as rodent adhesive, is a solid, tacky substance designed to capture small mammals when they walk across it. Proper use maximizes effectiveness while minimizing hazards.
First, select a location where target animals travel frequently—along walls, near entry points, or beneath cabinets. Ensure the surface is clean, dry, and free of dust. Wipe the area with a dry cloth; any moisture reduces adhesion.
Second, prepare the adhesive sheet or strip. If it arrives rolled, unroll it carefully to avoid tearing. Cut the sheet to a length that fits the chosen spot, leaving a margin of at least two inches on each side to prevent animals from stepping off the edge.
Third, position the glue on the floor or low vertical surface. Press firmly with the palm, applying even pressure across the entire surface. Avoid touching the sticky side with bare hands; wear disposable gloves to prevent skin contact and to keep the adhesive clean.
Fourth, monitor the trap. Check it at least twice daily. When a mouse is caught, wear gloves, place the entire sheet in a sealed plastic bag, and dispose of it according to local regulations. Do not attempt to release captured animals; the adhesive causes severe injury.
Fifth, after capture, clean the area. Remove any residue with a solvent compatible with the floor material—mineral spirits for tile, a mild detergent for hardwood. Rinse thoroughly and dry before considering re‑application.
Safety considerations:
- Keep adhesive out of reach of children and pets; label the area clearly.
- Store unused sheets in a sealed container, away from heat sources.
- In case of accidental skin contact, wash the affected area with soap and water immediately; seek medical advice if irritation persists.
Troubleshooting tips:
- Poor capture rate often results from improper placement; relocate the trap to a high‑traffic path.
- Excessive dust reduces tack; clean the surface before each use.
- If the adhesive loses its stickiness, replace it; the product has a limited shelf life once exposed to air.
By following these steps, the adhesive can be employed effectively to manage rodent problems.