How to make glue for catching rats? - briefly
Combine equal parts corn starch and water, heat while stirring until a thick paste forms, add a few drops of dish soap, then cool to a sticky consistency. Apply the adhesive to a flat surface and position bait nearby to attract rodents.
How to make glue for catching rats? - in detail
Creating an effective adhesive trap for rodents requires a clear understanding of the ingredients, preparation steps, application methods, and safety precautions.
Begin with the base mixture. Combine equal parts of industrial-strength contact cement and a high-viscosity silicone sealant. Stir the blend thoroughly until a uniform, glossy consistency forms. If the mixture is too thin, add a small amount of powdered polyvinyl acetate (PVA) to increase tackiness without compromising spreadability.
Next, incorporate a deterrent to prevent non‑target animals from contacting the glue. Mix in a few drops of peppermint oil or a mild citrus extract; these scents are unattractive to mammals but do not affect the adhesive properties.
Transfer the prepared solution into a disposable container with a narrow spout. Apply a thin, continuous layer onto a sturdy surface such as a wooden board, metal tray, or thick cardboard. Use a brush or spatula to spread the glue evenly, leaving no gaps. Allow the coating to cure for 10–15 minutes; the surface should become tacky but not fully hardened, ensuring that any rat that steps onto it will become immobilized quickly.
Position the traps along established rodent pathways: near walls, behind appliances, and in dark corners. Secure each trap with tape or brackets to prevent movement. Check the devices at least twice daily. When a rodent is caught, wear thick gloves, place the board in a sealed plastic bag, and dispose of it according to local regulations for pest control waste.
Clean up any stray glue promptly. Use a solvent such as mineral spirits or a commercial adhesive remover to dissolve residues on floors or countertops. Ventilate the area while working with solvents, and wear protective eyewear and respiratory protection.
Maintain the traps by replenishing the adhesive every 3–5 days, as environmental dust and humidity reduce effectiveness. Store any unused mixture in a sealed container at room temperature; it remains viable for up to two weeks.
Follow these procedures to produce a reliable sticky trap, maximize capture rates, and minimize hazards to humans and non‑target species.