How to correctly apply mouse glue to cardboard? - briefly
Apply a thin, even layer of adhesive to the cardboard surface, allowing it to become tacky but not fully dried before placing the mouse trap. Position the trap so the glue contacts the cardboard directly, then press gently to ensure full contact without spreading excess.
How to correctly apply mouse glue to cardboard? - in detail
Applying adhesive designed for trapping rodents to a cardboard surface requires preparation, precise placement, and safety measures.
First, select a glue that remains effective at the temperature where the cardboard will be used. Verify that the product label indicates suitability for porous materials; otherwise, the glue may soak unevenly.
Second, prepare the cardboard. Lay the sheet on a flat, stable surface. Remove dust, debris, or moisture with a dry cloth. If the cardboard is glossy, lightly sand the intended area with fine‑grain sandpaper to increase surface roughness, then wipe away dust.
Third, handle the glue container with care. Wear disposable gloves to avoid skin contact. Open the seal and stir the contents gently if the product has settled. Use a disposable applicator (e.g., a wooden stick or plastic spatula) to transfer a small amount of adhesive onto the cardboard. Apply the glue in a thin, uniform layer, no thicker than a few millimeters, covering only the target zone where the mouse is expected to travel. Avoid spreading the adhesive beyond the intended spot, as excess can drip and create a hazard.
Fourth, allow the glue to set. Most rodent traps reach peak tack within 5–10 minutes. Keep the treated cardboard undisturbed during this period. If the environment is humid, extend the setting time by a few minutes to ensure the adhesive fully cures.
Fifth, position the prepared cardboard in the trapping area. Place it against a wall or under a piece of furniture where rodents are known to travel. Secure it with tape or staples, ensuring the glued side faces upward and is flush with the surrounding surface.
Sixth, monitor the trap. Check the cardboard regularly, at least once daily, to assess capture status and to replace the adhesive if it dries out or becomes contaminated. Dispose of used glue and cardboard according to local hazardous‑waste guidelines.
Safety considerations:
- Keep glue out of reach of children and pets.
- Work in a well‑ventilated area to avoid inhaling fumes.
- Dispose of gloves and applicators after each use.
By following these steps, the adhesive will adhere effectively to the cardboard, providing a reliable surface for rodent capture.