How should mouse netting be installed correctly? - briefly
Measure each opening, cut the netting with an extra inch on all sides, then fasten it firmly using staples or nails and seal the perimeter with caulk to prevent gaps. Verify the installation for any openings or tears and repair them immediately.
How should mouse netting be installed correctly? - in detail
Proper installation of mouse netting begins with a thorough assessment of the target area. Identify all entry points, including gaps around doors, windows, vents, and utility penetrations. Measure the dimensions of each opening and the surrounding surfaces to determine the required netting length and width, allowing an extra 10 % for overlap and trimming.
Select a netting material with a mesh size of 1 mm or smaller, preferably stainless steel or galvanized wire for durability. Cut the netting to the calculated dimensions using wire cutters or a utility knife, ensuring clean, straight edges to prevent fraying.
Secure the netting in place using the following steps:
- Anchor preparation – Install stainless‑steel staples, screws with washers, or heavy‑duty adhesive strips at intervals of 6–8 in (15–20 cm) along the perimeter of the opening.
- Attachment – Position the netting against the surface, overlapping the edges by at least 2 in (5 cm). Press the anchors through the mesh and fasten them securely, maintaining tension to avoid sagging.
- Sealing – Apply a silicone‑based sealant around each fastener and along the perimeter to close any residual gaps.
- Reinforcement – For high‑traffic zones, add a secondary strip of netting or a rigid metal frame to increase resistance to tearing.
Inspect the completed barrier for continuity. Verify that no visible holes, loose threads, or unsealed joints remain. Conduct a visual check from both interior and exterior perspectives, and perform a tactile test by gently pulling the netting to confirm firm attachment.
Maintain the installation by scheduling quarterly inspections. Replace any compromised sections immediately, and clean the mesh with mild detergent and water to prevent corrosion. Regular upkeep ensures the barrier remains effective against rodent intrusion.