How should mouse glue be correctly applied?

How should mouse glue be correctly applied? - briefly

Apply a thin, uniform layer of adhesive to the underside of the mouse, covering the entire surface without overflow. Press the mouse onto the coated area, maintain pressure for the manufacturer‑specified duration, then let the glue cure completely.

How should mouse glue be correctly applied? - in detail

Applying mouse adhesive correctly requires preparation, precise placement, and safe removal. Follow these steps to ensure optimal results.

1. Surface preparation

   • Clean the target area with a mild detergent or alcohol wipe; remove dust, grease, and residues.
   • Allow the surface to dry completely before proceeding.

2. Adhesive selection

   • Choose a product formulated for rodents, preferably non‑toxic and low‑odor.
   • Verify that the glue’s viscosity matches the intended use: thin for smooth surfaces, thicker for textured ones.

3. Application technique

   • Dispense a thin, even layer using a disposable brush or sponge; avoid pooling.
   • Cover only the intended capture zone, leaving surrounding areas untouched to prevent accidental contact.
   • Work quickly, as the adhesive begins to set within seconds.

4. Trap placement

   • Position the trap in a high‑traffic corridor, near walls, or beside objects the mouse frequents.
   • Ensure the trap is stable and not exposed to direct sunlight, rain, or strong drafts, which can alter the glue’s effectiveness.

5. Monitoring and removal

   • Check the trap at regular intervals, typically every 30‑60 minutes, to minimize animal distress.
   • When capture occurs, wear disposable gloves and use a rigid tool (e.g., a spatula) to lift the mouse without tearing the adhesive.
   • Transfer the animal to a humane container if release is intended, or follow local regulations for disposal.

6. Post‑use cleanup

   • Dispose of the used adhesive and trap according to municipal waste guidelines.
   • Clean the surrounding area with a solvent recommended by the glue manufacturer, then rinse with water and dry.

Adhering to these procedures maximizes capture efficiency while maintaining safety for both the user and the animal.