How should glue be applied for mouse traps? - briefly
Apply a thin, uniform layer of adhesive to the trap surface, covering the entire capture area without excess pooling. Allow the glue to cure for a few minutes, then place the trap in locations where rodent activity is observed.
How should glue be applied for mouse traps? - in detail
Applying adhesive to rodent capture devices requires precise preparation, uniform coating, and safety precautions.
Begin by selecting a flat, dry surface on the trap. Remove dust, grease, or debris using a lint‑free cloth dampened with isopropyl alcohol. Allow the area to dry completely before proceeding.
Spread the glue evenly across the designated zone. Use a disposable brush or a thin spatula to lay down a continuous film of approximately 0.3 mm thickness. Avoid excess buildup, which creates pools that reduce effectiveness and increase the risk of accidental contact. The adhesive should remain tacky for at least 24 hours before exposure to rodents.
Safety measures include wearing nitrile gloves to prevent skin contact and working in a well‑ventilated area to limit inhalation of volatile compounds. Keep the trap out of reach of children and non‑target animals.
Routine inspection is essential. Check the adhesive daily for contamination or loss of tack. Replace the glue layer when it becomes dry, cracked, or covered with debris. Disposal of used adhesive follows local hazardous‑waste guidelines.
Key steps:
- Clean and dry the trap surface.
- Apply a uniform, thin adhesive layer.
- Allow curing time before placement.
- Employ protective equipment and ventilation.
- Monitor and replace the glue as needed.