How do you make a trap for a rat? - briefly
Create a snap trap by attaching a spring‑loaded bar to a wooden base, securing a baited plate, and positioning the device along rodent pathways. Adjust the trigger so the bar releases when the rat steps on the plate.
How do you make a trap for a rat? - in detail
To construct an effective rodent capture device, gather the following items: a sturdy wooden board (approximately 30 × 15 cm), a length of 1‑meter nylon cord, a small metal spring or a piece of elastic rubber, a sturdy nail or screw, a bait such as peanut butter or dried fruit, and a disposable glove for handling.
Begin by securing the spring or elastic to one end of the board, attaching it to a fixed point on the opposite side so that it creates a tensioned arm capable of snapping shut. Drill a small hole near the board’s edge, insert the nail, and bend it to form a trigger lever. Position the bait on the lever’s tip; when the rodent contacts the bait, its weight will depress the lever, releasing the tensioned arm.
Next, attach the nylon cord to the opposite end of the board, allowing the trap to be positioned on a flat surface without sliding. Ensure the cord is long enough to pull the board into a concealed corner after activation, preventing the animal from escaping.
Place the device along known rodent pathways—near walls, behind appliances, or in dark corners—where signs of activity are evident. Check the trap every 12 hours; if a capture occurs, wear a disposable glove, transport the board to a disposal site, and release the animal at a safe distance from the property, or follow local regulations for humane euthanasia.
Maintain the trap by inspecting the spring or elastic for fatigue, replacing the bait regularly, and cleaning the board to eliminate odors that could deter further activity.