How do you correctly apply glue for mice? - briefly
Apply a thin, even coat of non‑toxic adhesive to the trap surface, avoiding excess that could immobilize the animal, then place the trap in an area of mouse activity and allow the glue to set for a few minutes before use.
How do you correctly apply glue for mice? - in detail
Applying adhesive traps to capture rodents requires careful preparation, strategic placement, and diligent monitoring.
Select a trap designed specifically for small mammals. Verify that the adhesive surface is intact and free of dust. Store traps in a dry environment until use.
Prepare the area where activity is suspected. Identify pathways, near walls, behind appliances, and along baseboards. Clean surfaces to remove debris that could reduce adhesive effectiveness.
Place each trap with the sticky side facing upward. Position the trap perpendicular to the wall, with the edge nearest the anticipated travel route. Ensure the trap is stable; secure it with tape or a small weight if the surface is uneven.
Monitor traps at least once daily. Check for captured rodents, dead or alive, and replace traps promptly to maintain efficacy. Dispose of captured specimens according to local regulations, using sealed containers.
When handling traps, wear disposable gloves to avoid skin contact with the adhesive. In case of accidental adhesion to skin, apply oil or an adhesive remover to release the bond safely.
Maintain records of trap locations and capture dates. Analyze patterns to adjust placement, concentrating effort on high‑activity zones.
Regularly rotate trap positions to prevent rodents from learning avoidance behaviors. Replace expired or degraded adhesive surfaces to ensure consistent performance.
By following these steps, adhesive traps can be employed effectively to control rodent presence while minimizing risk to non‑target animals and humans.