How do you apply glue for catching mice? - briefly
Apply adhesive traps on flat surfaces near mouse pathways—behind cabinets, along walls, and close to food sources—pressing them firmly to ensure full contact with the floor. Check traps daily and replace any that become saturated or lose tack.
How do you apply glue for catching mice? - in detail
Applying adhesive traps to capture mice requires careful selection, placement, and monitoring to maximize effectiveness while minimizing hazards.
Choose a product specifically formulated for rodents. Verify that the adhesive surface is non‑toxic to humans and pets, and that the trap complies with local pest‑control regulations. Store traps in a sealed container until use to preserve stickiness.
Prepare the area before placement:
- Identify high‑traffic zones by observing droppings, gnaw marks, and paths along walls.
- Clear clutter that could obstruct the trap or cause accidental contact.
- Ensure the floor is dry; moisture reduces adhesive strength.
Position the traps:
- Place traps perpendicular to the wall, with the sticky side facing the expected direction of travel.
- Set traps at a height of 2–4 cm above the floor, aligning with the mouse’s natural movement corridor.
- Use multiple traps spaced 1–2 m apart in each identified zone to increase capture probability.
- Secure traps with tape or a small nail to prevent displacement by other animals.
Safety considerations:
- Keep traps out of reach of children and non‑target species.
- Wear disposable gloves when handling traps to avoid skin contact with adhesive.
- If a trap is accidentally touched, rinse skin with warm, soapy water promptly.
Monitoring and disposal:
- Inspect traps at least once daily. Replace any trap that has captured a mouse or that shows reduced adhesion.
- To dispose of a captured mouse, cover the trap with a sealed plastic bag, place it in a secondary container, and follow local waste‑disposal guidelines.
- After removal, clean the surrounding area with a mild disinfectant to prevent disease transmission.
Regularly reassess placement based on new activity signs. Adjust trap density and location as needed to maintain control over the rodent population.