How can you apply mouse glue to cardboard? - briefly
Coat the cardboard with a thin, even layer of mouse adhesive using a disposable brush or small roller, then press the trap or bait onto the wet glue and let it cure for a few minutes before use.
How can you apply mouse glue to cardboard? - in detail
Applying mouse adhesive to cardboard requires preparation, proper selection of glue, and controlled application to achieve effective trapping without damaging the material.
Begin by choosing a suitable adhesive. Commercial mouse glue products are formulated for quick drying and strong bonding. Verify that the glue is compatible with porous surfaces; most brands list cardboard as acceptable.
Prepare the cardboard surface. Ensure it is clean, dry, and free of dust or oil. Wipe the area with a dry cloth; for heavily soiled pieces, use a mild detergent, rinse, and allow complete drying.
Place the cardboard on a stable, flat surface. Position it where mouse activity is documented—along walls, near entry points, or under appliances. If the board is large, cut it into manageable sections (approximately 30 × 30 cm) to concentrate the adhesive and reduce waste.
Apply the glue using a disposable brush or a small spatula. Follow these steps:
- Measure the required amount—typically a thin, even layer covering 70–80 % of the surface, leaving a small margin of bare cardboard to prevent accidental spillage.
- Spread the adhesive uniformly, maintaining a consistent thickness of 1–2 mm. Avoid pooling, which can cause the glue to run and create hazardous drips.
- Smooth the layer with the brush edge to eliminate bubbles and ensure full contact with the cardboard fibers.
- Allow the coating to set for 2–3 minutes. The glue should become tacky but not fully cured, ensuring that a mouse will be immobilized upon contact.
Secure the treated board. Use tape or lightweight staples to fasten it to the floor or a wall, ensuring the adhesive side faces outward. Position the board so that the mouse encounters it from the intended direction; placing it perpendicular to travel paths maximizes capture probability.
Monitor the trap regularly. Check for captured rodents every 12–24 hours. When an animal is caught, wear disposable gloves, place the board in a sealed plastic bag, and dispose of it according to local pest‑control regulations. Clean the surrounding area to remove residual scent that could deter further activity.
If the adhesive dries prematurely, reapply a fresh layer following the same procedure. For extended use, store unused glue in a sealed container at room temperature, away from direct sunlight, to preserve its viscosity.