How do you correctly turn on a mouse repeller? - briefly
Press the power switch on the repeller, then configure the timer or sensor mode according to the manufacturer’s instructions. Ensure the device is placed in an open area free of obstructions before activation.
How do you correctly turn on a mouse repeller? - in detail
To power up a mouse repeller correctly, follow these steps:
-
Verify that the device is compatible with the local power supply. Check the voltage rating printed on the unit and match it with the outlet type (e.g., 110‑120 V or 220‑240 V). Using an incompatible source can damage the electronics.
-
Inspect the power cord for any signs of wear, cuts, or exposed conductors. Replace a damaged cord before connecting the unit to avoid electrical hazards.
-
Insert the plug firmly into a grounded wall socket. Ensure the socket is functioning by testing with another appliance or using a voltage tester.
-
Locate the activation switch, typically positioned on the front panel or side of the device. The switch may be labeled with a power symbol (⏻) or the word «ON». Flip the switch to the «ON» position; an indicator LED should illuminate, confirming that the unit is receiving power.
-
Allow the repeller a warm‑up period of 30 seconds to a minute. During this time, the ultrasonic transducers reach their operating frequency, usually between 20 kHz and 65 kHz, which is effective for deterring rodents without producing audible noise for humans.
-
Position the device according to the manufacturer’s layout recommendations: place it at least 1 meter away from walls, cabinets, or other obstacles that could block ultrasonic waves. For optimal coverage, install a unit in each major room where mouse activity is observed, maintaining a distance of 3‑5 meters between devices to prevent overlapping interference.
-
After installation, monitor for signs of rodent activity. If activity persists, adjust the location slightly or add additional units to expand the coverage area.
-
When the repeller is no longer needed, turn the switch to the «OFF» position, disconnect the plug from the outlet, and store the unit in a dry environment to preserve its components. Regularly clean the exterior with a soft, dry cloth to maintain performance.